> News > Industry News

Industry News

Extrusion Blow Molding Screw and Barrel: A Replacement Buyer's Checklist

Specify an extrusion blow molding screw and barrel replacement against the installed plasticizing unit, resin and regrind conditions, total melt demand, measured component condition and mating interfaces. Diameter and bottle volume alone are insufficient. Confirm whether the job restores the existin......

Injection Molding Screw Diameter and Shot Capacity: A Replacement Guide

Choose injection molding screws by checking the complete shot requirement against the installed injection unit's volume, pressure and plasticizing capability. Diameter alone cannot settle the choice. A larger screw can provide more volume while reducing the available injection pressure in a given ma......

Injection molding screw tip assemblies: check rings, types and replacement

Choose an injection molding screw tip assembly by its valve design, mating dimensions and resin conditions. A check ring is one component of a ring-type assembly, not a universal name for every screw-tip design. Before ordering a replacement, identify the complete assembly and inspect its mating par......

Cold feed vs hot feed rubber screw and barrel: differences and selection

Cold-feed and hot-feed rubber screws differ because they receive compound in different conditions. A hot-feed screw handles rubber warmed upstream; a cold-feed screw must also work and warm the incoming stock. That changes the working length, channel geometry, mixing requirements and temperature-con......

Single-screw extruder alignment: diagnosing uneven screw wear

Uneven screw wear is a reason to investigate alignment, not proof that alignment is the only fault. Compare the damage pattern with component measurements, the drive-to-barrel reference and the machine's thermal condition before replacing parts. A new screw can match its drawing yet still encounter ......

How to clean an extruder screw and barrel: purging, removal and inspection

Clean an extruder screw and barrel by matching the method to the residue, resin and installed equipment. Use an approved purge procedure for material displacement and changeovers; arrange mechanical cleaning when contamination persists or an inspection requires direct access. Cleaning is complete wh......

<1 2 3 4 5...18 >